https://www.kce.url.tw/en/custom_19566.html 3. Optional features-Added 1-5V Re-transmission 3. Optional features-Added 1-5V Re-transmission ▇ Added 1-5V Re-transmission function       I. The controller hardware modifications 1. Prepare 1-5V then transfer card 2. A further transfer card soldered on the motherboard 3. At 15.16 pin new terminal shrapnel   II. Controller software modifications     1. Press and hold "MODE" key 5 sec to enter  LEVEL 2 2. Set "Lock=1111" 3. Press and hold "MODE" key + "<" key 5 sec to enter  LEVEL 4 4. Set "St-5-2=1" (Default 0000 was revised to 0010) 5. Set "St-6-4=1" (Default 0001 was revised to 1001) 6. Press AUT key Back to LEVEL1 (Press and hold" MODE" key for 5 Back to LEVEL1) 7. Press and hold "MODE" key + "<" key 5 sec to enter  LEVEL 3 8. Set "Std=SV_4" 9. Adjustment Lo03 the output low=1v (Lo03 value of approximately 334) 10. Adjustment Hi03 The output high=5v (Hi03 value of approximately 4945) 11. Set "Std=PV_4"
https://www.kce.url.tw/en/ KE CHYUN ELECTRIC CO., LTD

▇ Added 1-5V Re-transmission function

 

 

 

I. The controller hardware modifications

1. Prepare 1-5V then transfer card

2. A further transfer card soldered on the motherboard

3. At 15.16 pin new terminal shrapnel

 

II. Controller software modifications

    1. Press and hold "MODE" key 5 sec to enter  LEVEL 2

2. Set "Lock=1111"

3. Press and hold "MODE" key + "<" key 5 sec to enter  LEVEL 4

4. Set "St-5-2=1"

(Default 0000 was revised to 0010)

5. Set "St-6-4=1"

(Default 0001 was revised to 1001)

6. Press AUT key Back to LEVEL1

(Press and hold" MODE" key for 5 Back to LEVEL1)

7. Press and hold "MODE" key + "<" key 5 sec to enter  LEVEL 3

8. Set "Std=SV_4"

9. Adjustment Lo03 the output low=1v (Lo03 value of approximately 334)

10. Adjustment Hi03 The output high=5v (Hi03 value of approximately 4945)

11. Set "Std=PV_4"