Custom Page

▇ Added 0-10V Re-transmission function

 

 

 

I. Hardware modifications

1. Prepare 0-10V Re-transfer card


2. A further transfer card soldered on the motherboard

 

3. Then 15.16 pin new terminal shrapnel

 

II. Controller set

1. Press and hold "MODE" key 5 sec to enter  LEVEL 2

2 .Set "Lock=1111"

3. Press and hold "MODE" key + "<" key 5 sec to enter  LEVEL 4

4. Set "St-6-3=1"

(Default 0100 was revised to 0110)

5. Press AUT key Back to LEVEL1

(Press and hold" MODE" key for 5 Back to LEVEL1)

6. Press and hold "MODE" key + "<" key 5 sec to enter  LEVEL 3

7. Set "Std=SV_4"

8. Adjustment Lo03 the output low=0v (Lo03 value of approximately 9)

9. Adjustment Hi03 The output high=10v (Hi03 value of approximately 1839)

10. Set "Std=PV_4"