▇ Added 0-10V Re-transmission function
I. Hardware modifications
1. Prepare 0-10V Re-transfer card
2. A further transfer card soldered on the motherboard
3. Then 15.16 pin new terminal shrapnel
II. Controller set
1. Press and hold "MODE" key 5 sec to enter LEVEL 2
2 .Set "Lock=1111"
3. Press and hold "MODE" key + "<" key 5 sec to enter LEVEL 4
4. Set "St-6-3=1"
(Default 0100 was revised to 0110)
5. Press AUT key Back to LEVEL1
(Press and hold" MODE" key for 5 Back to LEVEL1)
6. Press and hold "MODE" key + "<" key 5 sec to enter LEVEL 3
7. Set "Std=SV_4"
8. Adjustment Lo03 the output low=0v (Lo03 value of approximately 9)
9. Adjustment Hi03 The output high=10v (Hi03 value of approximately 1839)
10. Set "Std=PV_4"